RDC6585PC Control System manual
V1.0
SHENZHEN RUIDA TECHNOLOGY
49
8.6.6 Drip setting
Select the "drop setting" entry under the funtions interface, press the
<Enter>
key, and
then pop up the interface as follows:
There are two options for the fixed drop enable. Press the [OK] key to enter the modify mode (the
right side of the "blue selection block" becomes), press the "up/down" key to modify, press the [OK] key
after the modification is completed. Exit the modification mode. After all the modifications are completed,
move the “Select Block” to the “Write Parameter” item and press the [OK] key. The parameter setting
takes effect. Press the [Exit] key to return to the previous menu.
When “Yes” is selected, the fixed drop function is enabled, and the fixed drop function can be used
normally; when “No” is selected, the fixed drop function is invalid. The fixed drop position of the fixed
drop function can be set by "fixed drop coordinate X" and "fixed drop coordinate Y". The “drip interval
time” is the interval time of each fixed drop, and the “fixed drip time” is the time for the glue to be
dispensed each time.
8.6.7 Diagnose
Select the "Diagnose" entry under the funtions interface, press the
<Enter>
key, and
then pop up the interface as follows:
Figure 8.6.7-1
Figure 8.6.6
