7. ROTOR GUARDS AND LANDING STRUT
1. Included in the package you will find a screw driver, 2 x landing struts and 4 x rotor guards.
2. The 2 x landing struts will fit into the pre-drilled holes on the bottom of the quadcopter, use the screw driver to
tighten the screws.
3. The 4 x rotor guards will fit into the pre-drilled holes around each of the 4 rotors. Use the screw driver to tighten
the screws.
Screws
Screws
8. CHARGE THE QUADCOPTER BATTERY
Plug the USB charging cable into a USB power socket such as your PC, the charging indicator light will turn green.
Connect the rechargeable battery to the charging cable, indicator will then turn red. Once charging is complete,
indicator turns to green again.
Charging time is around 100 minutes.
9. PREPARATION & PAIRING
1. Please operate this quadcopter in spacious environment, avoid crowds, power lines and other obstructions. Avoid
using the quadcopter in bad weather as rain and wind may damage the unit.
2. Insert the quadcopter battery (Li-Polymer) into the quadcopter, the LED indicator will light on and immediately start
flashing. Make sure the quadcopter is level on the ground.
3. On your remote control, make sure the throttle stick is pushed to the lowerst position, then turn on the remote control’s
power switch. Now push the throttle stick to the highest and then to the lowest again. There will be a beep sound
and the quadcopter’s LED indicator stops flashing and remains steady. The paring is now complete and ready to fly.
