FenixS– user’s manual
Document Revision: 1.0
September 2021
9.1 Start and stop of flight recording
The unit will start recording immediately after start conditions are met. Start conditions are
based on ground speed and altitude change, so even if the GPS status is bad during takeoff, the
unit will start recording. It is recommended to switch the unit on a few minutes before takeoff.
After landing the unit will close the flight after approximately 20 seconds at standstill, so it is
recommended to keep the unit under power until flight is finished. To determine if the flight
recorder has closed the flight, check
Logbook->Statistic page
. If the Logbook appears, the
recording has finished, if the statistic page appears, the flight mode is still active.
45
