2009-2014 FORD F-150 SUPERCREW CAB WITH 6.5ft
LONG BED - RX7 WHEEL TO WHEEL
HARDWARE INCLUDED
RECOMMENDED TOOLS
12
8-1.25 x 25mm Hex Bolts
1 13mm Wrenches
12
8mm Lock Washers
Drill & 3/8
” Bit (Optional)
18
8mm x 22mm OD x 2mm Flat Washers
6
8mm Hex Nuts
6
8mm U-Nuts
RBP-325B-RX7
STEP 1- Locate the driver side step (The shorter bent side goes toward the front of the truck)
STEP 2- Remove any old steps and hardware, or remove any sealing tape and insulation that might be
covering the holes in the inner panel, remove as required from truck.
STEP 3- Start installation towards the front of the driver side of the vehicle. Locate the front set of
factory holes in the body panel and the (4) holes in the pinch weld under the front of the front door,
(Figure 1). Insert (1) 8mm U-Nut into the rectangular opening and line up the threaded hole in the U-
Nut with the round hole next to the opening. NOTE: Threaded nut must go towards the inside of the
body panel. Repeat this step on the center, (Figure 2), and rear set of factory holes, (Figure 1).
STEP 4- Place the driver side step up against the body panel. Attach the (3) top mounting tabs on the
step to the (3) U-Nuts with (3) 8mm x 25mm Hex Bolts, (3) 8mm Lock Washers and (3) 8mm Flat
Washers, (Figures 3 & 4). Do not tighten at this time. Attach the front and rear brackets to the pinch
weld with (2) 8mm Hex Bolts, (4) 8mm Flat Washers, (2) 8mm Lock Washers and (2) 8mm Hex Nuts,
(Figure 3). Note: Insert Hex Bolts in from the outside of the pinch weld and through the Bracket. Hand
tighten at this time.
Note: The center bracket will only attach to the U-Nut in the body panel and not to the pinch weld,
(Figure 5). If you wish to insert the 8mm x 25mm Hex Bolt through the bottom of the bracket for added
support, drilling will be required.
Optional Drilling- Locate the center set of holes, the measurement from center to center of the holes
should be 72mm (2 13/16”).
Measure 36mm (1 7/16
”)
in between both holes and place a mark on the
pinch weld with a paint marker or writing utensil, (Figure 5). Try to center the mark in line with the
factory holes in the bottom of the pinch weld to insure a proper alignment between the bracket and
the hole
in the pinch weld. Once you have verified the position of the center mark, drill a 3/8” hole for
the 8mm Hex Bolt.
STEP 5- Once the step is installed and the bolts are hand tight, verify the fitment and alignment. Once
everything is verified, torque the bolts down to 20lbs per square foot. Repeat steps for the passenger
side.
13000 Temple Ave. City of Industry, CA 91746 1-877-519-9090
June 2017
(JB)
