SNV-12 Operations Manual
6-3
6.3.2
Site Enable
ENABLE <SITE,ALL> <ON,OFF>
This command is used to enable or disable a given SVM from being voted. If a given site is
disabled, it may be manually selected by the SEL command. The site numbers range from 1 to
36. If a given site is not available, an error message is returned.
Examples:
ENABLE 1 ON
; Enables site 1 to be voted.
ENABLE 1 OFF
; Disables Site 1 (prevents it from voting).
ENABLE ALL OFF ; Disables all sites from being voted.
ENABLE ALL ON
; Allows all available sites to be voted.
6.3.3
Console Audio Transmission Select
TXSEL <SITE,ALL> <ON,OFF>
This command provides a means to send console audio to the selected site‟s associated
transmitter. When a site is selected for console transmissions, its TX Audio Output will be
enabled, and console audio present there, whenever the Console PTT input is activated. The
TXSEL command overrides all other console audio and PTT steering modes (including
STARS). If any sites are selected by TXSEL, then console audio will be transmitted from these
sites and no others. The site numbers range from 1 to 36. If a given site is not available, an
error message is returned. Multiple TXSEL commands can be used to send console
transmissions to multiple sites.
If a site or sites are selected by the TXSEL command, and are then deselected by the command,
console transmissions will return to where they would have been sent if the TXSEL command
had not been issued.
RX group selections or primary site designations do not affect TXSEL commands.
If a SVM is configured as an RX-Only site, its TX output cannot be enabled by RS-232 or any
other means.
Examples:
TXSEL 12 ON
; Sends Console transmissions to site 12.
TXSEL 12 OFF
; Removes TXSEL selection of site 12.
TXSEL ALL OFF
; Removes TXSEL selection from all sites.
TXSEL ALL ON
; Sends console transmissions to all sites.
Содержание SNV-12
