8.2.2 Load from Archive
You may already have stored the transformer you are up to measure on TR-MARK III or on a
memory stick.
In the Archive screen, make your choice by touching on a transformer with your finger. Tap
’Load’ to load it and append your measurement. Tap ‘Clone’ to create a new transformer,
based on the one you have chosen.
Touch the pictures on top (MARK III or memory stick) to choose between the sources. The
memory stick will only be displayed if connected.
If you are using a firmware version 3.0.97 or higher on a TR-MARK III 250V, profiles with
250V test voltage can be imported and exported as usual.
When using an older firmware version, or a common TR-MARK III, the test voltage of a 250V
transformer profile will be reduced to an available voltage automatically.
NOTE
Test Voltage will automatically be changed, if you are importing a 250V
transformer profile to a common TR-MARK III or if you are using a
firmware version prior to 3.0.97
90100-2.20 Instruction Manual TR-MARK III 250V
Page 36 of 68
Touch here to
choose source
