5.2 Single
The "Single"
mode allows a single test to be made. Turn the rotary knob until “Single” is
highlighted. Press the rotary knob to select. The test set will start a measuring sequence
immediately. The system will sense the current output, and if a valid reading is detected, then
record the results on the display. The results can then be “Stored” or “Printed”.
5.3 Cont...(Continuous)
The "Cont..." (Continuous)
mode allows a single test to be made continuously. The instrument will
continuously measure until the operator presses “Stop”.
Turn the rotary knob until “Cont” is highlighted. Press the rotary knob to select. The test set will
start measuring immediately. The system will sense the current output and, if it is a valid reading,
display the results on the display. If the STOP button is selected the last valid reading displayed will
remain on the display.
5.4 Auto (Automatic)
The
"Auto"
(Automatic) mode will measure and store, automatically, numerous single sequential
tests. The instrument will continuously measure multiple tests until the operator selects and
presses “Stop”.
For this type of measurement, please use the optional Kelvin probes.
Turn the rotary knob until “Auto” is highlighted. Press the rotary knob to select.
The test set will start measuring immediately and prompt the operator to make Contact with the
test probes. The system will sense the current output, and if it is a valid reading, then display the
results on the display. The instrument will automatically save this last result in a memory location
and then prompt the operator to remove the test probes (Remove Contact). The instrument will
then repeat the process. Press the STOP button to end the measuring sequence.
90081-2.11 Micro Junior 2
Page 11 of 44
NOTE:
NOTE:
The instrument will halt the measuring process if excessive interference is
detected.
If a warning message,”Rx Too High” is displayed, Or if ”+++.+” is displayed,
Then return to the “SET UP” screen and select the next higher resistance
range.
