Raytech CAPO 2.5, Инструкция по эксплуатации

Страница: 6 / 117

Preliminary
1 Safety Precautions
The following safety precautions must be observed during all phases of operation, service and
repair of this instrument. By purchasing this equipment the purchaser assumes all liability for the
operation and use of this equipment. The intended use of the instrument, its design and
manufacture, is to be conducted within the precautions or other specific warnings located within
this manual. Failure to comply with these precautions and other specific warnings violates the
safety standards of design, manufacture, and intended use. Raytech assumes no liability for the
operation and use of this equipment.
1.1 Safe operation
Only qualified, knowledgeable persons should be permitted to or attempt to operate this test
equipment. All test personnel should fully familiarize themselves with the correct application and
operation of this and all test equipment prior to operation. Persons directly and indirectly engaged
in the operation of this test equipment should keep clear of all high voltage apparatus while
conducting tests and measurements.
1.2 Ground the Instrument
To minimize shock hazard, the Ground Terminal on the instrument must be properly connected to
an Earth grounded point. In many cases, the quality of the safety ground terminal provided by the
power cord does not fulfil the safety requirements.
Also the power cord supplied with the equipment must be connected to an electrical receptacle
with an electrical ground (safety earth ground).
90315-1.2 Instruction Manual CAPO
Page 6 of 117
WARNING ! WARNING !
Never connect the Instrument to an energized Transformer!
WARNING !
WARNING !
Non-grounded Instruments are dangerous and may cause damage to
personnel and to the Instrument.