UK/Europe Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
Toll Free: +1 888 505 8335
13.2
PIN Function Detail :
The PIN is set by using the Vario Remote Control (VRC). There are five buttons /
characters on the remote that can be used for this purpose. They are Power 5, Power
1, Min Photocell (Smallest moon), Max Timer (Full Red Circle) & Timer Disable ( Timer
Circle image with a line through) . Note – invalid characters will not be recognised.
To create a PIN, press STATUS BUTTON for 4 seconds. LHS LED will flash RED/GREEN.
This indication will always show that you are in PIN mode. RHS LED FLASHING RED
shows there you are in PIN set mode. The number of flashes indicates how many
characters are required to complete the PIN entry. There are four characters to be
entered to successfully set up a PIN.
As you enter the characters, the number of flashes will decrease until all characters are
entered. Note, illegal characters will not be recognised and will not reduce the number
of flashes. When the PIN is set the illuminator will revert to Programming Mode.
When a PIN is Set :
Using the remote you can access the illuminator settings from operating mode by
entering the PIN.
You cannot access Programming Mode by power re-cycling only.
In operating mode, if you want to go back into programming mode simply enter your
PIN. To do this, press STATUS BUTTON for 4 seconds. LHS LED will flash RED/GREEN to
show you are in PIN mode. RHS LED FLASHING GREEN shows that a PIN has been
previously set. As you input the four correct characters the number of flashes will
reduce and you will be returned to programming mode.
If legal characters but not the correct sequence of characters is entered the number of
flashes will still reduce and after 4 characters have been entered an error will be
shown by both LED`s flashing RED.
If an illegal character is used when entering a pin, it will be ignored and the PIN
character count will not reduce.
To delete an existing PIN you first need to be in Programming Mode by entering your
PIN. Once in Programming Mode, press STATUS BUTTON for 4 seconds to go into PIN
set mode. LHS LED will flash RED / GREEN and RHS LED FLASHING RED. Instead of
entering one of the known legal characters press the RESET BUTTON four times. The
illuminator will return to programming mode. Note – if you delete the PIN and the
illuminator times out into operating mode, you will not be able to go back to
programming mode without recycling the power.
