2
1
1
2
3
5
6
7
8
3
5
3
6
3
7
3
8
RM07 (Optional)
Single Color LED Controller
Wireless Remote Control
Model: P12(-S)
Full Protection
High Power
Wireless Remote
Waterproof
Compact Size
Wide Voltage Range
P12 single color LED controller is designed to drive
constant voltage LED products in voltage range of DC5-
24V. The main unit works with a RF remote controller, user
can setup LED brightness from the remote controller. The
main unit is powered by DC power supply and receives
remote controller commands to drive LED fixtures.
Introduction
1. Power supply input
Wiring & Indicator
The controller supply voltage range is from DC 5V to
24V. The red power cable should be connected to power
positive and black to negative. (For other cable color,
please refer to the labels). The LED output voltage is at
same level as the power voltage, please make sure the
power supply voltage is correct and the power rating is
capable for the load.
2. LED output
Connect constant voltage LED loads. Please connect
red cable to LED+ and black cable to LED-. Please make
sure the LED rated voltage is same as the power supply
and each channel’s maximum load current is in range of
the controller rated current.
3. Work status indicator
This indicator shows all working status of the
controller. It displays different events as following:
Steady blue
: Normal working.
Short white blink
: Command received.
White blink
for 3 times
: New remote paired.
Single yellow flash
: Edge of the content.
Red flash
: Overload protection.
Yellow flash
: Overheat protection.
Please connect the controller output to LED loads
and power supply to the controller power input. The
power supply voltage must be same as the LED load's
rated voltage. Check all cables to be well connected
and insulated before power on.
To 110/230
AC power
5-24V DC output
Power supply
P12 LED
Controller
Constant voltage
LED load
Remote
Controller
5-24V DC
5-24V Driving
4. Wiring diagram
5. Turn ON / OFF
Press this key to turn on or turn off the light. Cotnroller
will memorize the on/off status and will restore to the
previous status on next power on.
Please use remote controller to turn on the unit if it
was switched to off status before previous power cut.
Functions
6/7. Brightness adjust
Press key to increase brightness and press
key to decrease. Hold press to adjust brightness smoothly.
When controller is at ‘OFF’ status, user can also hold
press key to turn on the light to minimum brightness.