Raymarine ST60 Tridata, Руководство пользователя

Страница: 18 / 54

6 ST60 Speed Instrument Owner’s Manual
1.3 Display settings
Illumination
When the instrument is first powered up, the display illumination is set to
its lowest (courtesy) level to facilitate initial access to the keys. To adjust
the level of illumination:
1. Hold down the speed key for approximately one second, to enter the
illumination-adjust mode.
2. There are four preset illumination levels. Press the
speed
key to
cycle through the these levels until you reach the level you want.
3. Press any other key to leave the illumination-adjust mode.
Note: The display will time out to normal operation 7 seconds after the
last key press.
Contrast
To adjust the display contrast:
1. Hold down the speed key for approximately two seconds, to enter
the contrast-adjust mode.
2. There are four preset contrast settings. Press the
speed
key to cycle
through the these settings until you achieve optimum display quality.
3. Press any other key to leave the contrast-adjust mode.
Note: The display will time out to normal operation 7 seconds after the
last key press.
1.4 Pop-up Pilot
A Pop-up Pilot facility enables instruments connected to SeaTalk to con-
stantly monitor any changes to the autopilot mode and to the course set-
tings. If one of these parameters changes, the new value is immediately
displayed on the ST60 instrument for 5 seconds, after which time the dis-
play reverts to the previous display.
This facility can be enabled or disabled during User calibration (see
Chapter 4, Calibration ).
PDF test 81037_4.book Page 6 Friday, July 26, 2002 11:08 AM