Raymarine RVM-100, Руководство по установке

Страница: 21 / 56

6.1 Location requirements
The guidelines below should be followed when selecting a location for the
transducer.
Note:
Optimum transducer location will vary depending on vessel type. Optimum
transducer height and angle should be obtained by testing the transducer
with the vessel in the water.
• The transducer is NOT suitable for mounting on vessels where the transom
is aft of the propeller(s).
• To obtain the best location for your transducer, observe the transom whilst
underway. Install in an area away from wake caused by the propeller(s)
and where the least amount of turbulence and aeration occurs.
• Turbulence can be caused by chines (1), skegs (2), strakes, (3), outlets and
exhausts (4), rows of rivets (5) steps (6) and ribs (7). Do NOT install your
transducer aft of these locations or in areas of turbulence created by them.
Note: The illustration above provides potential transducer locations for
the hull types depicted. Before selecting a location ensure that all of
the location requirements have been met.
• The transducer should be mounted as close to the centerline of the vessel
as possible, ensuring that:
– if the centerline has a chine (is pointed) the transducer is offset.
– the transducer remains submerged when planing and turning.
– the transducer is a sufficient distance from the propeller(s).
• The transducer should be mounted a minimum of 380 mm (15 in) away from
the propeller(s). For clockwise rotating propellers, mount the transducer
on the starboard side, for counter-clockwise, mount on the port side. On
a twin engine vessel mount the transducer close to the centerline or just
offset from the centerline.
• The transducer should be positioned so that the bottom half of the
transducer is lower than the lowest point of the hull in the vicinity of the
transducer. In the following illustrations, the dashed line indicates the
lowest point of the hull in the vicinity of the transducer.
Location requirements
21