Raymarine Lighthouse Sport 3.10 Series, Инструкции по продвинутой эксплуатации

Страница: 30 / 178

2. If your installation required you to install an all-in-one transducer backwards (e.g.: this may
occur when connecting the transducer to a trolling motor), then select Backwards from the HV
transducer alignment option. This ensures that the port and starboard channels appear correctly
orientated onscreen, otherwise keep the default setting: Forwards .
3. Select where you want your depth measurements taken from:
i. Below transducer (default) — No offset required
ii. Below keel — Enter the distance between the transducer face and the bottom of the keel.
iii. Below waterline —Enter the distance between the bottom of your keel and the waterline.
4. You can configure temperature settings as follows:
i. Enable or disable temperature readings as required.
ii. If enabled, check the temperature reading against the actual water temperature.
iii. If the current reading requires adjustment, select
Calibrate temp and enter the difference
between your 2 readings.
Identifying engines
Engine data can be shown on your display, if your engines are transmitting the relevant supported
data on the same network as your display. If your system has mislabelled your engines then you can
correct this using the Engine identification wizard.
The Engine identification wizard can be accessed from the Boat details menu: Homescreen >
Settings > Boat details > Identify engines .
1. Ensure the correct number of engines is selected in the Num of Engines: box.
2. Select Identify engines .
3. Follow the onscreen prompts to complete the engine identification wizard.
Performing a settings or factory reset
Performing a Factory reset will erase ALL user data and reset the display’s settings to their Factory
default values. Performing a Settings reset will restore your display’s settings to factory defaults,
whilst retaining user data.
1. Select
Settings reset , from the This display menu: Homescreen > Settings > This display >
Settings reset to perform a settings reset.
2. Select Factory reset , from the This display menu: Homescreen > Settings > This display >
Factory reset to perform a factory reset.
Importing user data
You can import user data (i.e.: GPX format Waypoints, Routes and Tracks) to your display.
1. Insert the MicroSD card that contains your user data files into the memory card reader on your
display.
2. Select Import from card from the Import/export menu: ( Homescreen > Settings > Import/export
> Import from card ).
3. Navigate to your User data file (.gpx).
4. Select the relevant GPX file.
Your user data has now been imported.
5. Select OK .
4.3 Shortcuts
The Shortcuts menu can be accessed by pressing the Power button.
30