Raymarine LIGHTHOUSE 4, Руководство по эксплуатации

Страница: 51 / 504

5.1 Switch on / off
Axiom® and Axiom® 2 displays with a power swipe
Switching on the display
When the display is powered but in standby the power swipe area will be
illuminated.
To switch on the display:
1. Swipe your finger from left to right across the power swipe area.
The display will boot up.
Switching the display to standby
When the display is switched on follow the steps below to put the display
into standby (switch off).
Display standby
1. Swipe your finger from left to right across the power swipe touch control
The Shortcuts menu is displayed.
2. Press and hold the [Power symbol] until the screen switches off.
Note:
When in standby, the display may still draw a small amount of power from
the battery. If this is a concern, unplug the power supply or switch off at
the breaker.
Removing power
If you wish to ensure that the display is not consuming any power then it must
be switched off at the breaker or have the power cable unplugged.
When the breaker is switched back on, or the cable is reconnected, the
display will resume in the same power state that it was in when it was
switched off.
Axiom® and Axiom® 2 displays with a power button
Switching on the display
1. Press the power button to switch on the display.
The display will boot up.
Getting started
51