RayTech USB2 to hsb
2
Interface Box
3
The USB2 to hsb
2
Interface Box connector panel provides the following indicators:
•
STATUS
is a green LED that lights when the Interface Box is operating properly.
•
RECON
is an amber LED that lights when there is an error situation.
•
USB
is a green LED that lights when the unit is properly connected to the PC.
•
3
is a green LED that lights when the PC is properly connected to the Interface
Box and the USB firmware is loaded.
•
2
is a green LED that blinks when the unit is powered on and then lights solid
when the unit is properly connected to the network and receiving data on Port
2.
•
1
is a green LED that blinks when the unit is powered on and then lights solid
when the unit is properly connected to the network and receiving data on Port
1.
Hardware Installation
The Raymarine USB2 to hsb
2
Interface Box is designed to be mounted in a dry
location where it is:
•
protected from physical damage and excessive vibration
•
protected from exposure to rain, salt spray and direct sunlight
•
well ventilated
Mounting
To install the Interface Box:
1
. Use the four mounting holes to secure the Interface Box in the desired location.
2. Attach the required cables.
DC Power Connection
The USB2 to hsb
2
Interface Box is intended for use on boat’s DC power systems rated
from 10 to 36 volts. A 5ft (1.5 m) power cable is supplied for connecting the boat’s
DC power to the unit. The power cable may be extended by up to 60 ft (20 m) using
a wire gauge of AWG 12 or greater.
DC power is connected at the POWER connector on the unit’s connector panel. The
RED wire must be connected to the feed from the positive (+) battery terminal and
the BLACK wire to the feed from the negative (–) battery terminal. The other wires
in this cable are not used.
The Interface Box is reverse polarity protected and has a current draw of 400ma @
12VDC or 5 watts (max).
