2. Place the small sealing ring in the groove located
on the bottom of the Mounting tray.
3. Secure the tray to the bracket using 3 of the
supplied screws, in the positions indicated in the
illustration above.
4. Place the large sealing ring into the groove on
the upper side of the Mounting tray.
5. Pull the SeaTalkng® cable through the canter of
the bracket and tray. Plug in the cable connector
on the underside of the unit and secure by
rotating the locking collar clockwise 2 clicks.
6. Insert the unit into the mounting tray, ensuring
the tabs in the Mounting tray are slotted into the
grooves around the edge of the unit.
Important:
The unit must be mounted with the LED ‘arrow’
in parallel alignment with the longitudinal axis
(centerline) of the vessel and be pointing towards
the vessel’s bow.
7. Orientate the Mounting trim so that the release
hole is accessible when mounted.
8. Place the Mounting trim over the unit slightly
offset, and then twist the Mounting trim clockwise
until it locks into position.
Releasing the unit from the adaptor
Follow the steps below to release the unit from the
Mounting adaptor.
1. Insert the flat of a small flat blade screw driver,
or similar tool into the release hole located on
the flat edge of the mounting adaptor and twist
the screw driver 90°, so that there is a small gap
between the Mounting trim and Mounting tray.
Important:
To help prevent scratching the product,
cover the tip of your screw driver with a small piece
of insulation tape.
2. Twist the Mounting trim counter-clockwise
approximately 10° and then lift away from the
unit.
45