Raymarine Element 7 HV, Руководство по установке

Страница: 18 / 82

Note:
When using third party transducers only the 200 kHz channel will be available.
Compatible legacy transducers
DownVision™ transducers
The following DownVision™ transducers can be connected to Element™ HV displays using the CPT-S
/ DownVision 9–pin adaptor cable (A80559):
Part number Description
A80507 CPT-90 DVS — DownVision™, Transom mount, Plastic transducer.
A80351 CPT-100 DVS — DownVision™, Transom mount, Plastic transducer.
Replaced A80270.
A80277 CPT-110 — DownVision™, Thru-hull, Plastic transducer with fairing block.
A80350 CPT-120 — DownVision™, Thru-hull, Bronze transducer with fairing block.
Replaced A80271.
Dragonfly® transducers
The following Dragonfly® transducers can be connected to Element™ HV displays using the Dragonfly
10–pin adaptor cable (A80558):
Part number Description
R70374 CPT-DVS — DownVision™, Transom mount, Plastic transducer.
A80278 CPT-70 — DownVision™, Thru-hull, Plastic transducer with fairing block.
A80349 CPT-80 — DownVision™, Thru-hull, Bronze transducer with fairing block.
High CHIRP sonar transducers
The following conical beam, high CHIRP sonar transducers can be connected to Element™ HV
displays using the CPT-S/DownVision 9–pin adaptor cable (A80559):
Part number Description
E70342 CPT-S High CHIRP, Transom mount, Plastic transducer.
E70339 CPT-S High CHIRP, 0° angled element, Flush mount, Thru-hull, Plastic
transducer.
A80448 CPT-S High CHIRP, 12° angled element, Flush mount, Thru-hull, Plastic
transducer.
A80447 CPT-S High CHIRP, 20° angled element, Flush mount, Thru-hull, Plastic
transducer.
A80446 CPT-S High CHIRP, 0° angled element, Flush mount, Thru-hull, Bronze
transducer.
E70340 CPT-S High CHIRP, 12° angled element, Flush mount, Thru-hull, Bronze
transducer.
E70341 CPT-S High CHIRP, 20° angled element, Flush mount, Thru-hull, Bronze
transducer.
Legacy transducer extension cables
When connecting a compatible legacy transducer to an Element display, using an adaptor cable:
if the cable run requires extending, you must use an extension cable which is compatible with
your transducer.
Important:
The HyperVision™ extension cable cannot be used to extend the cable run of legacy transducers.
18