Raymarine e7D, Руководство по установке и эксплуатации, Страница: 55 / 270

5.5 Bracket (trunnion) mounting
The display can be mounted on the supplied bracket.
Before mounting the unit ensure that you have:
• Selected a suitable location.
• Identified the cable connections and route that the cables will take.
• Attach the front bezel.
D 12273-1
1. Mark the location of the mounting bracket screw holes on the
chosen mounting surface.
2. Drill holes for the screws using a suitable drill, ensuring there is
nothing behind the surface that may be damaged.
3. Use the supplied screws to attach the mounting bracket securely.
4. Attach the display unit to the mounting bracket.
Note: The appropriate torque to use when drilling depends on the
thickness of the mounting surface and the type of material.
5.6 Front bezel
Attaching the front bezel
The following procedure assumes that the unit has already been
mounted in position.
1. Carefully lift one edge of the screen protection film, so that it is
accessible for removing when unit installation is complete.
2. Ensure the memory card slot door is in the open position.
3. Orientate the bottom-right side of the bezel under the lip of the
chart card door and place the bezel over the front of the display,
ensuring that the clips along the bottom edge of the bezel latch
into position.
D 12274-1
4. Ensure the bezel is correctly aligned with the display, as shown.
5. Apply firm but even pressure to the bezel along the:
i. Outer edges - work from the sides upwards and then along
the top edge, to ensure that it clips securely into position.
ii. Inner edges - particularly along the chart card door edge, to
ensure that the bezel sits flat.
6. Check that all control buttons are free to operate.
Removing the front bezel
Before proceeding ensure the memory card slot door is open.
Location and mounting
55