Raymarine e7D, Руководство по установке и эксплуатации, Страница: 54 / 270

5.3 Flush mounting
You can mount the display in a flush or panel mounting arrangement.
Before mounting the unit, ensure that you have:
• Selected a suitable location.
• Identified the cable connections and route that the cables will take.
• Detached the front bezel.
D 12271-1
1. Check the selected location for the unit. A clear, flat area with
suitable clearance behind the panel is required.
2. Fix the appropriate cutting template supplied with the product, to
the selected location, using masking or self-adhesive tape.
3. Using a suitable hole saw (the size is indicated on the template),
make a hole in each corner of the cut-out area.
4. Using a suitable saw, cut along the inside edge of the cut-out line.
5. Ensure that the unit fits into the removed area and then file
around the rough edge until smooth.
6. Drill 4 holes as indicated on the template to accept the securing
screws.
7. Place the gasket onto the display unit and press firmly onto the
flange.
8. Connect the power, data and other cables to the unit.
9. Slide the unit into place and secure using the provided screws.
Note: The appropriate torque to use when drilling depends on the
thickness of the mounting surface and the type of material.
Note: The supplied gasket provides a seal between the unit and
a suitably flat and stiff mounting surface or binnacle. The gasket
should be used in all installations. It may also be necessary to
use a marine-grade sealant if the mounting surface or binnacle is
not entirely flat and stiff or has a rough surface finish.
5.4 Attaching the rear bezel
The rear bezel must be fitted before mounting the unit on the
supplied trunnion bracket.
1. Remove the front bezel. Refer to the separate instructions
provided for that procedure.
2. Place the bezel over the rear of the display, ensuring that it is
correctly aligned with the display. Apply firm but even pressure
to the bezel along the:
i.
Outer edges - work from the sides upwards and then along
the top edge, to ensure that it clips securely into position.
ii. Inner edges - ensure that the bezel sits flat against the unit.
D 12183-2
* = e 7 / e 7D
= c95 / c97 c125 / c127 / e 95 / e 97 / e 125 / e 127
* 3
2
1
3. Use the supplied screws to secure the bezel to the display.
54 e7 / e7D / e95 / e97 / e125 / e127 / c95 / c97 / c125 / c127