Raymarine E70141, Инструкция по установке и эксплуатации, Страница: 31 / 70

6.3 Data master
Where a system contains more than one unit capable of displaying
a data type (e.g. depth can be displayed on the i40 Depth and i40
Bidata), the unit physically connected to the transducer must be set
as the data master and any other units set as a repeater.
Setting a unit as data master
1. Simultaneously press and hold the
Down
and
Action
buttons
for 4 seconds.
The software version page is displayed.
2. Press the Action button to display the instrument status.
Note: The i40 Bidata requires an extra Action button push to
switch from depth instrument status and speed instrument status.
3. Use the Up and Down buttons to change the instrument status
between Master and Repeater.
4. To save your settings and return to normal operation from any
page, simultaneously press and hold the Down and Action
buttons for 2 seconds.
6.4 Adjusting the backlight
The backlighting can be adjusted using the Action button.
During normal operation:
1. Press and hold the
Action button for 1 second.
The current backlighting level is displayed.
2. Press the Action button again to cycle through the available
backlight settings.
3. To return to normal operation press the Up or Down button, or
wait for the 5 second time-out.
4. Alternatively press and hold the Action button for 1 second to
adjust the contrast.
Getting started
31