Raymarine E70058, Инструкция по установке и эксплуатации, Страница: 41 / 68

Note: Depth offset information is only available on units set as
data masters (see Data master section for details.
7.3 i50 Speed operation
When connected to the relevant speed or speed and temperature
transducer, your i50 Speed instrument provides:
• Current, maximum and average speed information, in either knots
(KTS), mile per hour (MPH) or kilometers per hour (KPH).
• Log and trip information, in either nautical miles (NM), statute
miles (M) or kilometers (KM).
• Water temperature information, in either degrees celsius (ºC) or
fahrenheit (ºF).
• Velocity made good (VMG) information, VMG is only available
when connected to SeaTalk or SeaTalk ng network which also
contains a compatible wind transducer.
• Speed over ground (SOG) information, SOG is only available
when connected to SeaTalk or SeaTalk ng network which also
contains a suitable GPS.
• Count-up and race start timers
Note: The required speed, distance and temperature units are
selected during User calibration.
It should be noted that:
• The maximum speed, average speed and trip reading are reset to
zero at power up.
• The log screen shows the total distance covered by the vessel
since the unit was fitted.
Using the speed pages
To cycle through the speed pages follow the steps below:
S pe e d
S pe e d
S pe e d
S pe e d
S pe e d
1 0
15
20
25
30
35
40
45
50
55
60 5
8
1 0
15
20
25
30
35
40
45
50
55
60 5
8
Re s e t
1 0
15
20
25
30
35
40
45
50
55
60 5
3
Re s e t
1 0
15
20
25
30
35
40
45
50
55
60 5
3
D12533-1
1
2
3 4
5
With the Current speed page displayed:
1. Press the Speed button to display the Maximum speed page.
2. From the Maximum speed page:
i. Press the Speed button to display the Average speed page,
or
ii. Press and hold the Reset button for 3 seconds to set the
maximum speed value to the vessel's current speed.
3. From the Average speed page:
i. Press the Speed button to display the VMG page, or
Note: The VMG information is only available if your unit is part
of a SeaTalk or SeaTalk ng network which has a compatible wind
instrument connected.
ii. Press and hold the Reset button for 3 seconds to set the
average speed value to zero.
Using your display
41