6.1 Initial power on test
Once the unit has been correctly installed check that it is operating correctly.
After powering on, the unit will take approximately 25 seconds to start up. From powering on through
to normal operation, the LED status indicator should be solid green, changing to blinking green
when normal operation is underway. If the LED status indicator is not blinking green then refer to
the troubleshooting section of this handbook.
Open the Fishfinder application on your connected multifunction display and ensure that it is
operating correctly.
Operation instructions
For detailed operation instructions for your product, refer to the documentation that accompanies
your display.
All product documentation is available to download from the Raymarine website:
.
CP370 — Legacy multifunction display transducer set up
To set up the sonar module / transducer on an
E Classic
,
C-Series Widescreen
,
E-Series Widescreen
or
G-Series
the following steps must be followed:
1.
Select the relevant transducer from the set-up menu.
2. Wait 10 seconds for the change to take effect
Selecting the transducer
From the main fishfinder screen:
1. Press the
MENU
button.
2. Select
Fishfinder Setup
from the list of options.
3. Select
Transducer Settings
from the list of menu options:
4. Use the
Select Transducer
option and select the appropriate transducer from those available.
Important:
A transducer will be selected by default, if this is the same as the transducer you have
installed then you must re-select it from the list in order for it to be made the active transducer.
70
Содержание CP370
