Raymarine CAM300, Инструкция по установке и эксплуатации

Страница: 36 / 94

10.1 Power options
This product must be powered using ONE of the following methods:
1. PoE (Power over Ethernet) — Either:
• Direct connection to a PSE (Power Sourcing Equipment). Only one
cable is required to carry both data and power signals.
• Connection to a suitably-powered PoE injector or PoE network switch.
Only one cable is required to carry both data and power signals
between the camera and the PoE injector. However, the PoE injector
itself will require its own power source, and a separate ethernet
network cable to a PC, Raymarine® multifunction display or Raymarine®
network switch. The PoE injector method is useful if the camera is
located a long distance from a power source.
2. Self-powered
• Direct connection to a vessel's power supply using the supplied power
cable. With the direct connection method, a separate ethernet network
cable is required when connecting to a PC, Raymarine® multifunction
display or Raymarine® network switch.
Warning: Powering PoE devices
PoE devices can be powered via an ethernet connection (PoE)
OR via a dedicated power cable.
NEVER connect a PoE device’s dedicated power cable when it
is being supplied PoE.
When the PoE device’s dedicated power cable is not
connected, any bare end wire connections must be separately
covered with insulation.
10.2 Power over Ethernet (PoE)
Power over Ethernet (PoE) is a system that allows electrical power to be
passed from a PSE (Power Sourcing Equipment) to a PD (Powered Device),
via a single ethernet connection. This means that one ethernet cable can
provide both power and data to a compatible device, simplifying installation.
The CAM300 is a Class 1 PD (Powered Device), which consumes 1 W Nominal
/ 1.8 W Maximum (IR LEDs ON), @ 12 V dc. Before connecting the camera,
ensure that your PSE’s maximum power output will not be surpassed. For
further information on your PSE’s maximum power output, refer to the
instructions that accompany the device.
PSE (Power Sourcing Equipment) power connection
The CAM300 can be powered via a PSE’s (Power Sourcing Equipment)
Ethernet connection.
1. CAM300.
2. PSE (Power Sourcing Equipment) providing PoE (Power over Ethernet)
to the camera (Axiom XL currently illustrated).
3. RJ45 to RJ45 waterproof coupler (4115028 — not supplied ).
4. RayNet (female) to RJ45 (male) adapter cable (A62360 — not supplied ).
5. Camera power cable — DO NOT CONNECT if the camera is being
supplied PoE (Power over Ethernet).
For further information on the cabling required, refer to the following section:
p.83 — RayNet to RJ45 adapter cables
36