Raymarine CAM300, Инструкция по установке и эксплуатации

Страница: 23 / 94

Note:
Where constraints on the installation prevent any of the above
recommendations
, always ensure the maximum possible separation
between different items of electrical equipment, to provide the best
conditions for EMC performance throughout the installation.
6.4 Suppression ferrites
• Raymarine® cables may be pre-fitted or supplied with suppression ferrites.
These are important for correct EMC performance. If ferrites are supplied
separately to the cables (i.e. not pre-fitted), you must fit the supplied
ferrites, using the supplied instructions.
• If a ferrite has to be removed for any purpose (e.g. installation or
maintenance), it must be replaced in the original position before the
product is used.
• Use only ferrites of the correct type, supplied by Raymarine® or its
authorized dealers.
• Where an installation requires multiple ferrites to be added to a cable,
additional cable clips should be used to prevent stress on the connectors
due to the extra weight of the cable.
6.5 Connections to other equipment
Requirement for ferrites on non-Raymarine cables:
If your Raymarine equipment is to be connected to other equipment using
a cable not supplied by Raymarine, a suppression ferrite MUST always be
attached to the cable near the Raymarine unit.
6.6 Compass safe distance
To prevent potential interference with the vessel's magnetic compasses,
ensure an adequate distance is maintained from the product.
When choosing a suitable location for the product you should aim to maintain
the maximum possible distance from any compasses. Typically this distance
should be at least 1 m (3.3 ft) in all directions. However for some smaller
vessels it may not be possible to locate the product this far away from a
compass. In this situation, when choosing the installation location for your
product, ensure that the compass is not affected by the product when it
is in a powered state.
6.7 Augmented Reality
If your product is being used for Augmented Reality it is important to consider
its position and directional view for operation.
Before proceeding, ensure that you have read and followed the advice
provided within the following section:
p.22 — General location requirements
Please consider the following recommendations to ensure reliable and
trouble free operation:
• Direction — the product should be pointing towards the vessel’s bow and
must be in parallel alignment with the longitudinal axis (centerline) of the
vessel.
• Tilt angle — the product should be tilted so the water and horizon are
clearly visible at all times.
Example: camera position and directional view
Location requirements
23