4.5 Network connection
Your MFD can be directly connected to a compatible product using the RayNet connection. Your
MFD can also be connected to a SeaTalkhs ® network when using a suitable network switch.
1.
RayNet to RayNet cable — Connect one end of the RayNet cable to your MFD and the opposite
end to a RayNet device or RayNet network switch.
2. RayNet to RJ45 cable — Connect the RayNet end of the cable to your MFD and the opposite end
to a RJ45 device or RJ45 network switch or coupler.
3.
Compatible network devices, such as a Network switch, Radar scanner, Sonar module, Thermal
camera etc.
Note:
• Refer to the instructions supplied with your network product for specific connection information.
• Refer to
for a list of available network cables.
Cable suppression ferrites
To ensure optimum EMC performance and to comply with applicable EMC regulations any RayNet
cables connected to this product must have a suppression ferrite fitted.
Three suppression ferrites are included with your display, one for each RayNet connection.
Fit a ferrite to each RayNet cable as shown below:
37
