Item
Connector
Connects to:
Suitable cables
7
HDMI Out
Display
HDMI cable (A80219)
8
Touch In
Display that supports
touchscreen output
USB A to USB B cable
(A80578)
9
Touch Out
Touchscreen compatible
PC/MFD
USB B to USB A cable
(A80579)
10
NMEA 2000
• SeaTalkng ® backbone
• NMEA 2000 backbone
• SeaTalkng ® to
DeviceNet adaptor
cable
• DeviceNet cables
11
Optional
grounding point
Vessel RF ground, or
negative battery terminal
Refer to
— optional dedicated
drain wire
section for
details
The
HDMI in
and
Video 2
analog connections share hardware internal to the MFD and so cannot be
used at the same time. If devices are connected to both connections then the
HDMI in
connection
will take priority.
Refer to
Chapter 9 Spares and Accessories
for available cables.
Connecting cables
Follow the steps below to connect the cable(s) to your product.
1. Ensure that the vessel's power supply is switched off.
2. Ensure that the device being connected has been installed in accordance with the installation
instructions supplied with that device.
3. Ensuring correct orientation, push cable connectors fully onto the corresponding connectors.
4. If applicable, engage any locking mechanism to ensure a secure connection.
5. Ensure any bare ended wire connections are suitably insulated to prevent corrosion due to
water ingress.
29
