Raymarine axiom pro 9 RVX, Руководство по установке

Страница: 44 / 360

4.5 Transducer connection
If your MFD includes a built-in sonar module then you can connect a transducer to your MFD.
• Axiom Pro RVX:
– 1 x 25 pin connector — connect to RealVision™ 3D transducers
– 1 x 11 pin connector — connect to 1kW transducers.
• Axiom Pro S
– 1 x 25 pin connector — connect to transducer adaptor cable A80490, the adaptor cable then
connects to a CPT-S series transducer.
Note:
1. Only CPT-S series transducers can be connected to Axiom Pro S variant MFDs.
2. Transducer extension cables are available.
3. Adaptor cables are also available that enable connection of different transducers. Refer to
Chapter 9 Spares and accessories for a list of available adaptor cables.
RealVision™ 3D transducer extension cable
For best performance, cable runs should be kept to a minimum. However, for some installations it
may be necessary to extend the transducer cable.
• 3 m (9.8 ft), 5 m (16.4 ft), and 8 m (26.2 ft) transducer extension cables are available (part numbers:
3 m - A80475, 5 m - A80476, 8 m - A80477).
• It is recommended that a maximum of two cable extensions are used, with the total cable length
not exceeding 18 m.
Axiom transducer adaptor cables
The following adaptor cable are available to enable connection of a wider selection of transducers.
Axiom DV adaptor cables
A80484
Axiom DV to 7-pin Embedded Transducer Adapter
A80485 Axiom DV to 7-pin CP370 Transducer Adapter
A80486 Axiom DV to 9-pin DV & 7-Pin Embedded Transducers Y-Cable
A80487 Axiom DV to 9-pin DV & 7-Pin CP370 Transducers Y-Cable
Axiom RV adaptor cables
A80488 Axiom RV to 7-pin Embedded Transducer Adapter
A80489 Axiom RV to 7-pin CP370 Transducer Adapter
44