Raymarine axiom pro 9 RVX, Руководство по установке

Страница: 185 / 360

3.3 Getting started
First power up
When you power up your new Multifunction Display (MFD) for the first time a number of actions
are required.
The list below shows the actions that should be performed on your new MFD:
1. Power on the display.
2. Select your Data master (only required on networks with more than 1 MFD).
3. Complete the Startup wizard (the wizard will not be shown if you are connecting to an existing
system that has already been set up).
4. Read and agree to the Limitations on Use disclaimer.
5. Select/check your preferred Data sources, if required.
6. Perform Engine identification, if required.
7. Select/check Transducer settings, if required
First power up Data master selection
Networks containing more than 1 MFD must have a designated Data master. The Data master is the
primary MFD in the network and should be the MFD that is connected to the SeaTalkng ® / NMEA
2000 CAN bus network and any other devices and sources of data in your system. The Data master
bridges the data over the SeaTalkhs ™ network to any compatible networked ‘repeater’ MFDs.
By default your MFD will be set as a Data master. If you are connecting to a network that already
includes MFDs then on first power up you will be requested to confirm your Data master.
The “Multiple Data masters found” warning will be displayed whenever a new MFD is added to
your network.
You can change your Data master at anytime by selecting Assign as Data master against a MFD
listed in the Network tab of the Settings menu: Homescreen > Settings > Network.
Startup wizard
If the MFD is being installed as a stand alone installation or as part of a new system, then the first
time the MFD is powered up the Startup wizard will be displayed. The Startup wizard will help
you configure important settings on your MFD.
Follow the onscreen instructions and configure the relevant settings.
The Startup wizard will also be displayed after a Factory reset is performed.
Set up
19