Raymarine AXIOM 2 PRO, Руководство по установке

Страница: 83 / 126

Possible causes Possible solutions
Sensitivity settings
may be inappropriate
for present
conditions. Check and adjust sensitivity settings or perform a
Sonar reset.
Damaged cables 1. Check the unit’s connector for broken or bent
pins.
2. Check that the cable connector is fully inserted
into the unit and that the locking collar is in the
locked position.
3. Check the cable and connectors for signs of
damage or corrosion, replace if necessary.
4. With the unit turned on, try flexing the power
cable near to the display connector to see if this
causes the unit to re-boot/loose power, replace
if necessary.
5. Check the vessel’s battery voltage, the
condition of the battery terminals and power
supply cables, ensuring connections are
secure, clean and free from corrosion, replace
if necessary.
6. With the product under load, using a
multi-meter, check for high voltage drop across
all connectors/fuses etc (this can cause the
Sonar applications to stop scrolling or the unit
to reset/turn off), replace if necessary.
Transducer location • Check that the transducer has been installed in
accordance with the instructions provided with
the transducer.
• If a transom mount transducer is mounted too
high on the transom it may be lifting out of the
water, check that the transducer face is fully
submerged when planing and turning.
Transducer
kicked-up If the transducer has a kick-up mechanism, check
that it has not kicked up due to hitting an object.
Possible causes Possible solutions
Damaged or fouled
transducer Check the condition of the transducer ensuring it is
not damaged and is free from debris / fouling.
Damaged transducer
cable Check that the transducer cable and connection
is free from damage and that the connections are
secure and free from corrosion.
Turbulence around
the transducer at
higher speeds may
affect transducer
performance Slow vessel speed and recheck.
Interference from
another transducer 1. Turn off the transducer causing the interference.
2. Reposition the transducers so they are further
apart.
Unit power supply
fault Check the voltage from the power supply, if this is
too low it can affect the transmitting power of the
unit.
19.5 Wi-Fi troubleshooting
Before troubleshooting problems with your Wi-Fi connection, ensure that
you have followed the Wi-Fi location requirements guidance provided in the
relevant installation instructions and performed a power cycle/reboot of the
devices you are experiencing problems with.
Cannot find network
Possible cause Possible solutions
Wi-Fi not currently
enabled on devices. Ensure Wi-Fi is enabled on both Wi-Fi devices and
rescan available networks.
Some devices may
automatically turn
off Wi-Fi when not in
use to save power. Power cycle / reboot devices and rescan available
networks.
Troubleshooting
83