Raymarine AXIOM 2 PRO, Руководство по установке

Страница: 41 / 126

Note:
Replacing a trunnion mounted or surface mounted Axiom® Pro display with
a new Axiom® 2 Pro display,
with the exception of the power cable , is a
straight swap with no hole drilling or cutting required.
8.3 Trunnion mounting — Axiom® 2 Pro 9 and
Axiom® 2 Pro 12
Tools required (trunnion mount installations)
The following tools are recommended for mounting using a trunnion bracket:
1. Power drill.
2. Screwdriver (appropriate for your fixings).
3. Drill bit (suitable for the material of the mounting surface and the 5.75 mm
(0.23 in) diameter mounting holes in the trunnion bracket.
Trunnion bracket mounting
Axiom® 2 Pro displays can be mounted on a trunnion bracket. Axiom® 2
Pro 9 and Axiom® 2 Pro 12 displays are supplied with a trunnion bracket.
An optional trunnion bracket kit is available for the Axiom® 2 Pro 16 (part
number: A80722).
Note:
Fixings to the secure the trunnion bracket to a mounting surface are not
provided. 5 x self tapping screws are required. The screws should be
suitable for the mounting surface material and the 5.75 mm (0.23 in)
diameter mounting holes in the trunnion bracket.
Ensure you have chosen a suitable mounting location for your display, which
has sufficient head room to allow the display’s angle to be adjusted or the
display to be removed if necessary. If installing ‘above head’ take extra care
to ensure the knobs are tightened sufficiently to prevent them coming loose
due to vibration when underway.
1. Check the underside of the mounting surface to ensure no damage will
be caused by drilling.
2. Check the thickness of the mounting surface to ensure it is sufficient to
support the display.
Installation 41