Note:
1.
Refer to
Compatible transducers for Axiom™+ RV Multifunction displays
for more information on compatible transducers for your MFD variant.
2. Transducer extension cables are available.
3.
MFDs that do not have a built-in sonar module can be connected to a transducer via an
networked sonar module.
RealVision™ 3D transducer extension cable
For best performance, cable runs should be kept to a minimum. However, for some installations it
may be necessary to extend the transducer cable.
• 3 m (9.8 ft), 5 m (16.4 ft), and 8 m (26.2 ft) transducer extension cables are available (part numbers:
3 m - A80475, 5 m - A80476, 8 m - A80477).
• It is recommended that a maximum of two cable extensions are used, with the total cable length
not exceeding 18 m (59 ft).
DownVision™ transducer extension cable
For best performance, cable runs should be kept to a minimum. However, for some installations it
may be necessary to extend the transducer cable.
• A 4 m (13.1 ft.) Transducer extension cable (A80273) is available.
• It is recommended that only one cable extension is used.
Axiom transducer adaptor cables
The following adaptor cables are available to enable connection of a wider selection of transducers.
A80488
Axiom RV to 7-pin Embedded Transducer Adapter
A80489
Axiom RV to 7-pin CP370 Transducer Adapter
A80490
Axiom RV to 9-pin DV Transducer Adapter
A80491
Axiom RV to 25-pin RV & 7-pin Embedded Transducers Y-Cable
A80492
Axiom RV to 25-pin RV & 7-pin CP370 Transducers Y-Cable
A80493
Axiom RV to 7-pin Embedded & 9-pin DV Transducers Y-Cable
A80494
Axiom RV to 7-pin CP370 & 9-pin DV Transducers Y-Cable
Caution: Transducer cable
• Do NOT use the transducer cable to lift or suspend the transducer; always
support the transducer body directly during installation.
• Do NOT cut, shorten, or splice the transducer cable.
• Do NOT remove the connector.
If the cable is cut, it cannot be repaired. Cutting the cable will also void the
warranty.
46
