Raymarine A80603, Руководство по установке

Страница: 20 / 58

3.3 Selecting a location
Warnings and cautions
Important: Before proceeding, ensure that you have read and understood the warnings and
cautions provided in the Chapter 1 Important information section of this document.
Location requirements
The guidelines below should be followed when selecting a location for the transducer.
Note:
The information below is provided for guidance only. Optimum transducer location will be different
for each vessel.
• To obtain the best location for your transducer, observe the transom whilst underway and install in
the area where the least amount of turbulence and aeration occurs.
• The transducer is NOT suitable for mounting on vessels where the transom is aft of the propeller(s).
• The transducer should be mounted as close to the centerline as possible, however if the centerline
is pointed the transducer should be offset from the centerline.
• For best performance the transducer must be installed in a location with the least turbulence and
aeration. The most effective way to determine this is by checking the water flow around the
transom whilst underway. Turbulence can be caused by chines (1), skegs (2), strakes, (3), outlets
and exhausts (4), rows of rivets (5) steps (6) and ribs (7). Do NOT install your transducer aft of these
locations or in areas of turbulence created by them.
20