Raymarine A80603, Руководство по установке

Страница: 18 / 58

3.1 Tools required
The following tools are required to install your transducer:
1. Power drill
2. 4 mm hex wrench (Allen key)
3. 5 mm hex wrench (Allen key)
4. Pozi-drive screw driver
5. Drill bit (suitable for pilot holes)
6. Marine grade sealant
7. 24 mm (15/16 in) or suitable size hole cutter (only required when routing the cable through a
bulkhead or transom)
8. Masking / adhesive tape
Warning: Marine-grade sealant
Only use marine-grade neutral cure polyurethane sealants. Do NOT use sealants
containing acetate or silicone, which can cause damage to plastic parts.
Anti-fouling
Where local regulations allow, it is recommended that you coat your transducer using a water-based
anti-fouling paint. This will help prevent the build-up of organic growth, which can reduce transducer
performance.
Important:
• Before applying water-based anti-fouling paint, check that local environmental rules and
regulations do not prohibit the use of anti-fouling paint.
• Never use copper-based anti-fouling paint as this can impact transducer performance.
• Never use ketone-based anti-fouling paint as this can attack the transducer’s plastic, damaging
the transducer.
18