4 INSTALLATION
© 2017 RAYLASE GmbH MINISCAN II
MN102-en / v1.0.3
22
4
INSTALLATION
Installation may only be carried out by trained personnel. These trained personnel must be familiar
with the general safety regulations that are applicable for installation and operation of opto-
mechatronic systems, machines and plants.
4.1
Safety during installation
WARNING
Hazard due to electrical energy
C 3-0 10. 1
The deflection unit is designed for intended operation on a safety extra-low voltage (< 60 V DC). The
operator is responsible for safe provision of the power supply (voltage limitation, shutdown on
overcurrent, line protection).
Make sure that the power supply does not exceed the specified low voltage.
During all work on the electrical power supply and the electrical systems, observe the relevant
electrical safety regulations.
WARNING
Risk of injury due to laser radiation
C2 -01 0
The laser beam (including a reflected beam) can cause severe injuries to the eyes and skin.
The laser system may only be installed and started up by trained personnel.
After all work, ensure that the laser system is switched off and secured against being switched
on again.
WARNING
Risk of injury due to falling deflection unit
C2 -030
A falling deflection unit can cause injuries.
The deflection unit should be installed by two people wearing suitable safety shoes.
