Raycon Move Wing RD 200, Инструкция по эксплуатации

Страница: 6 / 8

6
Part-01 Part-02 Part-03
Part-07 Part-08 Part-09
Part-10 Part-11 Part-12
Part-04 Part-05 Part-06
7.4V 1200 mAh Li-po battery
Main Blade A /B
RCB Board
Charger Motor Cover
Main Motor Main Frame
Landing Gear
Main Spare parts:
Transmitter
Camera Accessories
Upper Body
Red/Blue Line Motor
Red/Black Line Motor
Reset opertaion introduction:
(Figure 2)
(Figure 1)
1.Transmitter reset: When transmitter cannot control quadcopter normally, pls turn
off transmitter, then re-turn on transmitter, transmitter will reset automatically.
2.Quadcopter reset: When quadcopter cannot fly normally,
also the transmitter already reset, at this time, you can try
to reset the quadcopter. Reset way: Place the quadcopter
on the level ground, turn on, after frequency connect, pull
down transmitter rudder to left, keep 2-3 seconds, wait
quadcopter light turn flash to stable(Figure 1).
3.Headless mode adjust: If need to turn on headless mode
during play before quadcopter fly up, must adjust
headless mode first(Must adjust headless mode for every
time flight). Adjust way: Place quadcopter on the level
ground, head in front, back aim to controller before turn
on quadcopter, frequency connect, then pull down
transmitter rudder to right, keep 2-3 seconds, wait
quadcopter light turn flash to stable(Figure 2).
Front/back/Left /
right side fly Rudder
Throttle/Rudder(tun)
Throttle/Rudder(tun)
Front/back/Left/
right side fly Rudder