5
cause loss of control.
•
Cut only wood, as well as for pruning and cutting wood. Do not use the chain saw for any
other purpose. For example: do not use it to cut plastic, masonry or construction materials
other than wood. Using the chain saw for operations other than those specified may result
in hazardous situations.
•
Be careful when using the machine during stormy weather. Do not use the machine during
lightning, thunderstorms or in bad weather in general.
•
There is advantage of using the provided spiked bumper when cutting trees and thick
branches.
•
Perform regular functional check of the clutch. It should be no have chain movement at
idling speed.
•
When operating the tool, be careful of the emission of exhaust gases, lubrication oil mist
and saw dust; avoid to be exposed to these and wear protective equipment.
•
Wear protective gloves when assembly, disassembly, sharpening chain tensioning and
when handling the guide bar.
•
Guide-bar and chain adjustments shall be perform with the engine stopped.
•
Regularly check and test the chain brake.
•
Hazards may be encountered while using the saw, such as blockage of the saw chain.
In order to reduce hazards, follow the instruction for cutting operation; always
check the condition of the tool. Do not start the chainsaw directly in a tree.
Fuel Handling
•
Be very careful when handling fuels. They are flammable and the vapors are explosive.
•
Use only an approved container.
•
Never remove the fuel cap or add fuel while the machine is on. Turn off the unit and allow
the engine and exhaust components to cool before refueling.
•
Do not smoke.
•
Never refuel inside a room
•
Never store the tool and the fuel tray indoors where there is a naked flame, such as near a
water heater.
•
If fuel has spilled, do not attempt to start the machine, but rather move it away from the spill
before starting to use it. Clean any spills.
•
Replace and tighten the fuel tank cap after refueling.
•
Follow the instructions in this manual for filling the tool with fuel.
During maintenance and storage
•
Stop the tool and wait until it stops. Make sure all moving parts have come to a standstill.
•
Allow the machine to cool before performing inspection, adjustments, maintenance,
servicing and storage.
•
Store the tool where fuel vapor will not reach a flame or spark.
•
When transporting and storing, always place the tool in its transport guard and protective
device on it.
Causes of rebounds and prevention by the operator
•
Bounce may occur when the spout or end of the chain guide touches an object, or when
the wood tightens and pinches the cutting chain in the cutting section.
•
The contact of the tip may in some cases cause a sudden reverse reaction by bouncing the
chain guide up and back towards the operator.
•
Pinching of the cutting chain on the upper part of the chain guide can force the chain guide
to the operator abruptly.
•
Either of these reactions can result in loss of control of the saw likely to result in a serious
personal injury. Do not rely exclusively on safety devices built into your saw. As a chain
saw user, all measures should be taken to eliminate the risk of accident or injury during
cutting.
•
Bounce results from improper use of the tool and / or incorrect operating procedures or
conditions and can be avoided by taking the appropriate precautions specified below:
•
Hold the saw with both hands firmly with the thumbs and fingers encircling the handles of
the saw and place your body and arms to allow you to withstand the rebound forces. The
Содержание RAY45PCS-1
Страница 7: ...7 2 YOUR PRODUCT a Description...
