Raven SCS 5000 Series, Инструкция по установке и эксплуатации

Страница: 47 / 104

Manual No. 016-0159-925 Rev. F 39
Data Menu
computers. Refer to the Serial Baud Rate (SCS 4000/4070/5000 Only) section on page 38 to
reconfigure the serial communication baud rate if necessary.
COM 1 Stop Bits
Select between one or two stop bits for communicating with a GPS receiver.
Datalog Mode
Select between logging “GPS and Console Data” or “GPS Data only.” The master switch will pause the data
log if GPS and console data are being recorded. GPS data only creates a continuous log.
VRC
Enable or disable variable rate control through the serial and CAN ports. When VRC is disabled, the SCS
console will ignore variable rate information.
Product Submenu
Page 1
Boom Select
This feature allows the operator to assign products to individual boom sections. Products assigned to a boom
section will only be applied when the assigned boom section is turned on.
Note:
The equipment plumbing and electrical systems must accommodate any selections made for this
feature.
Once entering boom select mode, use the CE key to toggle between products and use keys 1 through 0 to
toggle the boom selection ON or OFF for booms 1-10 respectively. The boom status display indicator will show
the selected booms for the active product. All booms are initially selected ON for each product.
Press ENTER to exit boom select mode.
Off Rate %
This is the acceptable percentage (+/-) of the actual rate in relation to the target rate. The off rate alarm will
activate when the actual application rate (volume/area) is outside of this range for more than 5 seconds.
PWM High Offset
The PWM high offset is used to set the maximum desired RPM or hydraulic output of a PWM (Pulse Width
Modulated) control valve.
To calibrate the high offset value:
1.
Toggle the console to manual (MAN) mode and toggle any boom and master switches to the on position.
2.
Hold the INC/DEC switch in the increase position.