Raven SCS 5000 Series, Инструкция по установке и эксплуатации

Страница: 43 / 104

Manual No. 016-0159-925 Rev. F 35
Initial Startup & Console Programming
Decimal Shift
The decimal shift feature is used to increase system accuracy at low application rates. Decimal shift is set
during the setup of meter cal or product density.
Note:
The programmed rate cal value is also affected by the decimal shift feature. Be sure to verify the
programmed rate cal when changing the decimal shift feature.
To enable the decimal shift feature for the selected product:
1.
Press the METER CAL button.
2.
Press the ENTER key to enable Edit mode.
3.
Press the DISTANCE key. The rate display for the selected product will change to reflect the decimal shift.
4.
Enter the meter cal or product density for the selected product.
5.
Press the ENTER key to accept the value and exit Edit mode.
To disable the decimal shift feature for the selected product:
1.
Press the METER CAL button.
2.
Press the ENTER key to enable Edit mode.
3.
Enter the meter cal or product density for the selected product. The rate display for the selected product will
change to reflect the changed decimal.
4.
Press the ENTER key to accept the value and exit Edit mode.
The following tables illustrate how shifting the decimal point can increase system accuracy.
TABLE 1.
Decimal Place Locations in Liquid Mode
US Metric Turf
Unshifted Shift Unshifted Shift Unshifted Shift
Rate Display
0000.0 000.00 00000 0000.0 000.00 000.00
Rate Cal
0000.0 000.00 00000 0000.0 000.00 000.00
Tank Volume
000000 00000.0 000000 00000.0 00000.0 00000.0
Total Area
000.0 000.0 000.0 000.0 0000 0000
Total Volume
000000 00000.0 000000 00000.0 00000.0 00000.0
Field Area
000.0 000.0 000.0 000.0 0000 0000
Field Volume
000000 00000.0 000000 00000.0 00000.0 00000.0
Vol/Minute
0000 000.0 0000 000.0 000.0 000.0
Area/Hour
000.0 000.0 000.0 000.0 0000 0000
Rate +/-
000.0 00.00 0000 000.0 00.00 00.00
Low Tank Level
0000 000.0 0000 000.0 000.0 000.0
Low Vol/Min
0000 000.0 0000 000.0 000.0 000.0