Raven OmniSeed Viper Pro, Калибровка и руководство по эксплуатации

Страница: 192 / 308

Chapter 7
180 OmniSeed™ Viper Pro™ Installation & Operation Manual
Serial Communication Port Setup
The Viper Pro features three serial communication ports which may be configured to provide communication
between the field computer and various external devices. The serial ports are labeled as follows:
•
GPS Comm Port
•
Console Comm Port
•
Auxiliary Comm Port
GPS Comm Port Setup
To use the guidance capabilities of the VIper Pro field computer, a DGPS receiver must be connected to the
9-pin serial connector labeled ‘DGPS’ on the main interface or chassis interface cable. The GPS Comm Port
Setup screen is used to configure the Viper Pro field computer to receive GPS messages from the connected
receiver.
1.
To configure the GPS communication port from the Viper Pro main screen, touch Menu , and select Setup ,
Comm Ports . The GPS Comm Port Setup screen will display.
Communication settings must match the receiver settings exactly for proper communication between the
Viper Pro and the connected DGPS receiver. The following presets are available to help configure the GPS
Comm Port Setup screen:
•
Generic GPS - for RPR 410, Phoenix 300 and non-Raven receivers or with an optional guidance
or steering component (e.g. TM-1 Tilt Module, SmarTrax, etc.) connected between the receiver
and field computer
•
Raven GPS - for all other Raven receivers
2.
Select the appropriate preset to begin configuration of the GPS communication port.
Note:
Touch the View Data button to display the actual NMEA strings received by the field computer.
NMEA strings will not be displayed if the GPS Comm Port Setup does not match the
communication settings of the connected DGPS receiver.
3.
Refer to the following sections for details on completing the GPS Comm Port Setup for the available preset
settings.