
7
Manual No. 016-0171-148
123
Tools Menu
Internal GPS Receiver
To use the internal receiver, select the ‘Internal GPS Receiver’ option. Verify settings on the GPS Output
screen to ensure that any required messages are properly configured.
Via TM-1 or SmarTrax™
To output DGPS signal from the built-in receiver to an optional TM-1 Tilt Sensor or SmarTrax controller, select
the Internal GPS Receiver (Via Tilt or SmarTrax) option.
Note:
The GPS Output Baud must be set to 19,200 before selecting the Via TM-1 or SmarTrax option
(see the External Lightbar, TM-1 Tilt Module and SmarTrax™ section on page 122). Do not select
the this option if the optional hardware components are not connected. The field computer may
take several minutes to properly setup these components or may lock up if the
TM-1 or SmarTrax controller are not connected.
This option requires additional cables to route DGPS signal from the internal receiver out to the
TM-1 or SmarTrax controller and then back into the field computer. Review the installation sections
for these optional system components or contact a local Raven dealer for more information.
External GPS Receiver
If an optional external GPS receiver is connected to the field computer via the connector labeled ‘DGPS’ on the
main interface cable (P/N 115-0171-746) or chassis interface cable (P/N 115-0171-926) select the External
Receiver option. Selecting this option overrides the internal DGPS receiver.
Tilt Sensor
If the TM-1 Tilt Sensor is connected directly to the DGPS connector on the main interface cable (P/N 115-0171-
746) or chassis interface cable (P/N 115-0171-926), the Envizio Pro or Envizio Pro II may be used to configure
the TM-1. Touch the Tilt icon to access the Tilt Configuration screen.
Note:
When routing tilt corrected signal through a SmarTrax controller and back into the field computer,
the TM-1 must be calibrated through the SmarTrax controller rather than the Envizio Pro or Envizio
Pro II. See the SmarTrax Quick Start Guide or Operator’s Manual for more information.
Information
Touch the blue Information icon to display a brief explanation of the settings and options available on the Tilt
Configuration screen.
Note:
Refer to the TM-1 Tilt Module Installation and Operation Manual for detailed installation and
calibration information.
Содержание Envizio Pro
