Navigation Aid System Setup and Operation Manual
Page 19 of 21
10 Setup of 210 WiFi Navigation Aid System
This system contains a 210-WiFi GPS receiver, a WiFi WPI (Wireless Pilot Interface), a TBA-2 antenna,
50 feet of antenna cable, cable reel, antenna clamp, and a laptop computer.
This system is no longer in
production, and is gradually being replaced in the field by systems that use Bluetooth
communication.
Figure 17: 210 WiFi Navigation Aid System
10.1 Setup Steps
In general, the steps are:
1. Set up the computer and turn it on. You may apply 100-240 VAC power or use the internal laptop
battery.
2. Set up the antenna, as described later in this manual.
3. Connect antenna cable to DGPS unit. Connecting the antenna to the DGPS before applying
power ensures that the DGPS unit provides a position in the shortest possible time. If you have
turned the DGPS unit on without an antenna, turn it off for 10 seconds, connect the antenna, and
then turn it back on.
4. Plug in the DGPS to 100-240 VAC, unless it is the 210LB/Battery unit, which is battery-operated.
5. Set up the WPI as described earlier in this manual.
6. On the laptop computer, start the Raven navigation software, usually Wheelhouse II (WHII).
