QuickLock Operator Manual
27
QuickLock Operator Manual
– Version 15.07.01
2.5.4.3.
Passing through the projecting rubber end
When the packer passes through the projecting rubber end, the new sleeve catches it and pulls it
inwards.
Move the new sleeve into the previously fitted sleeve up to the first lock.
Move the sleeve back out.
The projecting rubber end will fold back outwards.
Note:
If you move it too far out, you must repeat the procedure.
Position the sleeve and proceed as above.
Note:
When moving back and forth to position the sleeve, there is a risk of catching the projecting
rubber end and creasing it. A tight seal is no longer possible.
2.5.4.4.
The correct metal overlap
The metal overlap between sleeves installed in series
is correct when the following conditions are met:
The edge of the new steel sleeve is 3/16-5/8
”
(0.5-1.5 cm) in front of the locking gear of the previous
sleeve.
The circumferential seals of the new sleeve form a tight seal
with the projecting rubber end of the previous sleeve.
Projecting rubber end
3/16” – 5/8”
