QuickLock Operator Manual
24
QuickLock Operator Manual
– Version 15.07.01
Two sleeve serial install
If you want to install two sleeves, it can be done with two beveled sleeves as follows:
Ideally, you should work
against the direction of flow
when installing the sleeves.
2.5.4.2.
Installation
Preparing and layout of the sleeves
(1) First sleeve, straight edge, with
projecting rubber end
(2) Second and any additional sleeves,
straight edge, with projecting rubber end
(3) Last sleeve, beveled end, without
projecting rubber end
Using the projecting rubber end
Slip the rubber gasket over the steel sleeve so that the
distance between the circumferential seal and the edge
of the sleeve (1)
is at least equal to the
distance between
the locking gar and the edge of the sleeve (2)
.
(1
) ≥ (2)
This ensures that the two circumferential seals form a tight
seal within the projecting rubber end.
1st QL sleeve, beveled end
2
nd
QL sleeve, beveled end
Direction of flow
