Rauch TWS 85.1, Инструкция по эксплуатации

Страница: 81 / 104

General maintenance and service
75
9
9.2.3 Maintenance plan for hydraulic system
9.3 Cleaning
Fertiliser and dirt promote corrosion.
We recommend cleaning the machine
a soft jet of water immediately after every
use in order to maintain its value.
The following instructions must be observed for cleaning:

Only clean oiled machines at washing points fitted with an oil separator.

When cleaning with high-pressure water, never aim the jet directly at warning
signs, electrical equipment and hydraulic components.
After cleaning, we recommend treating the dry machine, especially stainless
steel parts , with an environmentally friendly anti-corrosion agent.
A suitable polishing kit can be ordered from authorised dealers for use in treating
rust spots.
9.4 Opening the protective grid
The rear halves of the protective grid ((viewed in the direction of travel) are fold-
able.
The protective grids lock automatically by means of a protective grid lock.
Component parts Maintenance tasks
Maintenance plan Comment
Hydraulic hoses
Check condition
Replace after 6 years Page 84
Control block Check for damages/leaks before driving Page 85
n
WARNING
Risk of injury due to moving parts in the hopper
There are moving parts in the hopper.
There is a risk of injury to hands and feet during commissioning
and operation of the machine.
 It is important that the protective grid is installed and locked
before commissioning and operating the machine.

The protective grid may only be opened for maintenance
purposes or in the event of a fault.