Rauch QUANTRON, Дополнительные инструкции

Страница: 90 / 110

5 Spreading operation
The machine control unit helps you to enter the machine settings before starting work. During
spreading, functions of the machine control unit are also active in the background. This allows you to
monitor the quality of the fertilizer spreading.
Start or stop the transmission at low PTO speeds only .
5.1 TELIMAT border spreading unit
CAUTION!
Risk of injury due to automatic adjustment of the TELIMAT unit!
When the boundary spreading key is pressed, an electrical positioning cylinder automatically
moves the machine to the boundary spreading position. This may cause injury and property
damages.
▶
Before pressing the boundary spreading key , make sure that nobody is present in the
hazard zone of the machine.
The TELIMAT option is preset for the control unit at the factory!
TELIMAT with hydraulic remote control
The TELIMAT unit is hydraulically moved to its working or idle position. You can activate and
deactivate the TELIMAT unit by pressing the Limited border spreading key. Depending on the position,
the display shows or hides the
TELIMAT icon .
TELIMAT with hydraulic remote control and TELIMAT sensors
If TELIMAT sensors are connected and activated, the TELIMAT icon is shown on the display of the
control unit when the TELIMAT boundary spreading unit is hydraulically moved into its operating
position.
If the TELIMAT unit is moved back to the idle position, the TELIMAT icon is hidden again. The
sensors monitor the TELIMAT adjustment and automatically activate or deactivate the TELIMAT unit.
The boundary spreading key has no function with this option.
If the status of the TELIMAT unit cannot be detected for more than 5 seconds, alarm message 14 will
be displayed; see
6.1 Meaning of the alarm messages .
5. Spreading operation
90
5902662 QUANTRON-A AXIS/MDS