Rauch QUANTRON-K2, Инструкция по эксплуатации

Страница: 39 / 102

Operation QUANTRON-K2
33
4
4.5.3 Flow factor
The flow factor is within the range of 0.4 to 2.10 . At identical basic settings (km/h,
working width, kg/ha), the following applies:

If the flow factor is increased , the application rate decreases .

If the flow factor is reduced , the application rate is increased .
If you know the flow factor from earlier calibrations or from the fertiliser chart, you
can enter it
manually in this menu.
Entering the flow factor:
1.
Call up the Spreading mat. settings > Flow factor menu.
 The display shows the currently applied flow factor.
2. Enter the new value in the input field.
See chapter
4.11.2: Input of values using the cursor keys, page 65 .
3. Confirm input by pressing the Enter key .
 The new value is saved in the control unit.
NOTICE
Via the Calibration menu, the flow factor can be determined and entered using
the QUANTRON-K2. See chapter 4.5.5: Calibration, page 35
NOTICE
The flow factor calculation depends on the operating mode used. For further in-
formation on the flow factor is provided in chapter
4.6.2: AUTO / MAN mode,
page 46 .
NOTICE
If your spreading material is not listed in the fertiliser chart, enter a flow factor
of
1.00 .
In the AUTO km/h operating mode we highly recommend executing a calibra-
tion in order to be able to accurately determine the flow factor for this spreading
material.