Rauch QUANTRON-A, Инструкция по эксплуатации

Страница: 58 / 120

Operation QUANTRON-A 4
52
4.6.7 Spreading disc type
The mounted spreading disc type is preset in the control unit at the factory. If you
have mounted different spreading discs on your machine, you must enter the
correct type in your control unit.
1. Call up the Fertiliser settings > Spreading disc menu.
2. Highlight the spreading disc type with the bar in the selection list.
3. Press the enter key .
 The selected spreading disc type is marked with a tick.
4. Press the ESC key
 The display shows the Fertiliser settings window with the new
spreading disc type.
4.6.8 PTO
The set PTO speed is preset in the control unit to 540 rpm at the factory. If you
want to set a different PTO speed, change the value saved in the control unit.
1. Open the menu Fertiliser settings > PTO .
2. Enter the speed.
See chapter
4.14.2: Input of values using the cursor keys, page 88 .
3. Press the enter key .

The display shows the Fertiliser settings window with the new PTO
speed.
NOTICE
For an optimal idle measurement you must check that the entries in the
Fertiliser settings menu are correct.

The Spreading disc and PTO speed menu entries must match the actual
settings of your machine.
NOTICE
For an optimal idle measurement you must check that the entries in the
Fertiliser settings menu are correct.

The Spreading disc and PTO speed menu entries must match the actual
settings of your machine.
NOTICE
Please observe chapter : Mass flow control with the M EMC function, page 95 .