Machine settings
7
34
3.
Set the spreading vanes back in the direction of number 1.
Using this setting, the spreading material will be ejected
later
.
4.
Screw on the spreading vane (tightening torque: approx. 7 Nm).
Always use
a new self-locking
nut when screwing on the vane.
The spreading density on the right-hand side viewed in the direction of
travel is increased.
7.4.2
Increasing the spreading density on the left-hand side in the direction of travel
1.
Observe the rotational direction of the spreading disc. See
.
2.
Disassemble the screws of the spreading vanes including the corresponding
nuts and washers.
Figure 7.8:
Spreading density on the left in the direction of travel
White arrow: Rotational direction of the spreading disc
Grey arrow: Adjustment of the spreading vanes in the rotational direction of the sprea-
der disc
3.
Set the spreading vanes forward in the direction of number 5.
Using this setting, the spreading material will be ejected
earlier
.
4.
Screw on the spreading vane (tightening torque: approx. 7 Nm).
Always use
new self-locking
nuts when screwing on the vane.
The spreading density on the left-hand side viewed in the direction of
travel is increased.
Содержание K 51
