Rauch AXIS-M 20.2 EMC, Инструкция по эксплуатации

Страница: 70 / 236

General commissioning (all machine types) 8
50
AXISAXIS
8.2 Requirements for the tractor
To ensure a safe and correct use of the machine of the AXIS series, the tractor
must meet the necessary mechanical, hydraulic, and electrical requirements.

Universal drive shaft connection AXIS 20.2, AXIS 30.2/40.2 : 1 3/8 inches,
6 splines, 540rpm,

Universal drive shaft connection AXIS 50.2 : 1 3/8 inches, 6 splines, 700rpm,

Oil supply: max. 200 bar, single or double-acting valve (depending on equip-
ment)

Operating voltage: 12 V,

Three-point linkage, category II (AXIS 20.2, AXIS 30.2, AXIS 40.2)

Three-point linkage, category III (AXIS 50.2)
8.3 Mounting the universal drive shaft at the machine
Depending on the version, the machine may be equipped with different universal
drive shafts:

Universal drive shaft with shear pin protection (only AXIS 20.2),
-
See “Mounting the universal drive shaft with shear pin protection to
AXIS 20.2“ on page 91 .

Universal drive shaft with ratchet clutch,

Tele-Space universal drive shaft with ratchet clutch.
n
CAUTION
Material damages due to unsuitable drive shaft
The machine is delivered with a drive shaft that is designed according
to the device and performance.
The use of incorrectly dimensioned or inadmissible drive shafts, for
instance without guard or suspension chain, may cause personal
injury or lead to damage to the tractor and/or the machine.
 Use universal drive shafts approved by the manufacturer only.
 Follow the directions in the operator’s manual of the universal
drive shaft manufacturer.
NOTICE
The machine AXIS 20.2 (not for AXIS 20.2 MEMC) is equipped ex works and
delivered with a drive shaft with shear pin protection . If you wish to mount a
universal drive shaft and/or a Tele-Space drive shaft with ratchet clutch, please
refer to the following paragraph.