Rauch AXIS-M 20.2 EMC, Инструкция по эксплуатации

Страница: 67 / 236

Instructions regarding the spreading operation
47
7
AXISAXIS
7 Instructions regarding the spreading operation
The intended use of the machine includes compliance with the operating, main-
tenance, and service conditions in accordance with the manufacturer specifica-
tions.
Spreading therefore always includes preparation and
cleaning/maintenance .

Carry out spreading operations in accordance with the sequence described
below.
Preparation

Installing the spreader on the tractor Page 54

Close metering slide

Presetting the mounting height Page 58

Filling in the fertiliser Chapter A.2 or chapter A.3
1
1. See the register of your machine (AXIS 20.2, AXIS 30.2 or AXIS 50.2)

Adjusting the application rate Chapter B.2
1

Setting the working width
-
Selection of the correct spreading disc
- Adjusting the drop point
Chapter B.5
1
Chapter B.5.3
1
Spreading

Travel to the spreading location

Check the mounting height

Engage the PTO shaft

Open the slider and start spreading

Finish spreading operations, and close the
slides

Disengage the PTO shaft

Discharge residual material Chapter B.10
1
Cleaning/maintenance

Open metering slide

Remove the spreader from the tractor

Cleaning and maintenance
Chapter C
1
and AXIS mainte-
nance